Quite a few homeowners have decided to install a manufactured stone veneer instead of natural rock. In most situations it is a smart decision because they look the same, last forever and cost a lot less than the natural stone equivalent. Over time any type of veneer can become damaged, cracked or chipped just through normal wear and tear. Unlike natural stone, you can repair your own manufactured stone veneer in 5 easy steps. Before you get started with repairs, there are a few items that you will need to get including: a small broom, trowel, cold chisel, wire brush, a hammer, grout bag and mortar mix.

• Step One:  Find the damaged veneer piece and place the cold chisel on the grout line. It needs to be at a forty five degree angle with the tip of the chisel facing inward towards the stone piece. Lightly tap the hammer on all sides of the broken piece to loosen the grout and remove the stone. If it refuses to come loose, you may need to chip away at the piece itself until it comes free.
• Step Two:  Use the wire brush to clear away the debris and dust from where the stone piece was removed in step one. Be careful of the wire mesh inside the socket because you do not want to pull it away from the foundation of the veneer. That mesh is what you will be securing the new piece onto.
• Step Three: Measure the hole that was left and find a piece of stone veneer that will fit into it. If you cannot find one small enough you can use a wet saw to cut a large piece down to size.
• Step Four: Get a bucket and mix the mortar with water until it thickens into a paste.
• Step Five: Apply a thin coat to the wire mesh, otherwise known as a Skim coat. Then you can apply a half inch thick layer of mortar onto the Skim coat using a trowel. If that is too big then you can substitute a putty knife. Now apply a half inch layer of mortar to the back on the replacement stone piece and press it solidly into place. Once the piece is in position you can use a grout bag to squeeze out a line of grout around the perimeter of the new piece. After that the only thing left to do is wait for it to dry.